Urethane Crown Moulding

Ekena Millwork's urethane crown moulding gives trade buyers one of the deepest Endurathane profile selections in the category, from clean traditional coves to detailed dentil and egg-and-dart patterns. Molded from high-density polyurethane, every profile resists the moisture, warping, and cracking that pull wood crown out of spec, and each ships factory primed for a straight-to-paint install. Stock profiles ship within 24 to 72 hours, so dealers can commit to a ceiling deadline. Contact an Ekena rep for trade pricing or request crown samples.

A Crown Library Deep Enough to Standardize On

Ekena maintains an extensive Endurathane crown range spanning traditional, dentil, cove, and ornate detail profiles, in projections and heights that suit both modest residential ceilings and larger commercial spans. For a distributor, that breadth means fewer sourcing gaps and a single line that can anchor most crown specs.

Detail That Survives the Jobsite

High-density polyurethane holds fine ornamentation cast after cast, so a dentil or egg-and-dart run stays consistent from stick to stick. The material is light, which matters overhead: a single installer can carry and set long lengths without the sag and breakage that plague heavier crown. It also cuts and miters with standard tools, so there is no learning curve at the trim stage.

Moisture Resistance Where Ceilings Meet Reality

Crown often runs through kitchens and baths where steam and humidity are constant. Because Endurathane does not absorb water, it will not warp or rot in those rooms, which protects the finish line and reduces callbacks. Factory priming means the only remaining step is paint.